Últimas noticias

RIVERSIDE, CA - Nissan's first-ever full-size trucks have received rave reviews. K&N Engineering makes the 2005 to 2014 Nissan Armada SUV, 2004 Nissan Pathfinder, the impressive 2004 to 2014 Nissan Titan truck and the 2004 through 2010 Infiniti QX56 even more hype-worthy with the introduction of their High-Flow Fuel Injection Performance Kit, or FIPK^® (Part No. 57-6012). K&N engineers were able to unleash extra power and torque by eliminating the restrictive OE airbox and intake tract, replacing them with the FIPK^® Kit. Testing on K&N's Dynojet 248 dynamometer established a baseline of 254.07 HP on a stock 2004 Pathfinder 4x4. With the K&N FIPK^® Kit installed, the same vehicle averaged 265.28 HP, an increase of more than 11 horsepower!

Each K&N Intake Kit is engineered to virtually eliminate incoming-air restrictions. The process begins by choosing the largest conical K&N High-Flow Air Filter that will easily fit in the engine compartment. The filter's design increases airflow and its size traps more dirt, increasing service intervals up to 100,000 miles (depending on driving conditions). K&N High-Flow Air Filters are backed by the famous K&N Million Mile Limited Warranty^® and can be repeatedly cleaned and re-oiled with a K&N Recharger^® Kit (sold separately).

To further increase power, the filter is isolated from high engine temperatures by a heatshield. Also, K&N aerodynamically engineers the FIPK's intake tube specifically for the Armada/Titan using roto-molded high-density polyethylene, allowing the tube to be optimally shaped for minimize turbulence and improved airflow. The FIPK^® includes a mass-airflow sensor adapter that's strategically placed to work with factory equipment while permitting increased power.

Installation is purely bolt-on and uses factory holes: No drilling is required, and the average do-it-yourselfer can replace the stock airbox and intake tract with an FIPK^® using only common hand tools in about 90 minutes. The kit comes complete with all mounting hardware, nylon-reinforced silicon hose adapters and stainless-steel barrel clamps. The FIPK^® for the Armada, Pathfinder, Titan and QX56 is street-legal in most states.

K&N also offers two replacement filters for the stock Armada/Titan: a washable/reusable High-Flow Air Filter (PN 33-2286) and a Performance Gold Oil Filter (PN HP-1010).

For additional information, please contact K&N Engineering, Inc., P.O. Box 1329, Riverside, CA 92502-1329, (800) 213-4182 for a dealer near you, (800) 858-3333 for technical service/questions, (951) 826-4001 Fax, e-mail [email protected] or visit www.knfilters.com.

# # K&N # #

RIVERSIDE, CA - Inspired by the heart and soul of the 1960s the GTO has been dubbed the meanest, most powerful midsize American sports coupe in production. Backed by a six-speed manual transmission and independent rear suspension the 2004 GTO sports a 350 horsepower LS1 that begs for the additional benefits and performance K&N has been offering for more than 35 years.

By replacing your factory air intake assembly with K&N's 57-Series Fuel Injection Performance Kit (FIPK), 57-3044, your engine gets cool, dense air with less restriction. Producing an additional 18 rear wheel horsepower on K&N's in-house Dynojet 248 dyno, the FIPK utilizes K&N's high-flow, washable and reusable air filter, low-restriction air intake plumbing and a custom designed heat shield. Made for the do-it-yourselfer K&N's FIPK can be installed in 90 minutes or less with common hand tools. Best of all, K&N Intake Kits protect engines without voiding the factory warranty.

For more information, please contact K&N Engineering, Inc., P.O. Box 1329, Riverside, CA 92502-1329, (800) 213-4182 for a dealer near you, (800) 858-3333 for technical service/questions, (951) 826-4001 Fax, e-mail [email protected] or visit www.knfilters.com.

* Application for CARB exemption was pending at the time this press release was written. If CARB exemption is required for your application, please contact K&N for current information on the status of its CARB application.

# # K&N # #

RIVERSIDE, CA - Get more power and improved throttle response from your 2004, 2005, 2006 and 2007 Jeep^® Liberty 3.7L V-6 engine with a K&N 57-Series Fuel Injection Performance Kit (FIPK^®), PN 57-1540. The high-flow low restriction High-Flow Air Filter element is the cornerstone of the FIPK^® system. This filter can be cleaned dozens of times, and will save you money over the life of your Jeep^® Liberty. The engineers at K&N developed and dyno-tested the various components of the FIPK^® kit to extract hidden horsepower from the Jeep^® Liberty 3.7L engine by giving it what it needs to make power - more air.

Surrounding the High-Flow Air Filter element is a heat reflective metal shield. By isolating the K&N High-Flow Air Filter from engine heat, the shield helps keep incoming air cool for a denser, more powerful intake charge. Incoming air is further isolated from engine heat by a composite tube that connects the High-Flow Air Filter to the fuel injection intake. This tube is designed to optimize airflow velocity in order to improve throttle response and torque throughout the entire rpm range. You'll also love the throaty engine sound that the K&N FIPK^® kit unleashes from your Jeep^® engine at full throttle.

K&N FIPK^® kit for Jeep^® Liberty bolts on easily in under 90 minutes and requires only basic hand tools for installation. All K&N FIPK^® kits are 50-state legal and the High-Flow Air Filter element is backed by the famous K&N Million Mile Limited Warranty . For more information, please contact K&N Engineering, Inc., P.O. Box 1329, Riverside, CA 92502-1329, (800) 213-4182 for a dealer near you, (800) 858-3333 for technical service/questions, (951) 826-4001 Fax, e-mail [email protected] or visit www.knfilters.com.

* Application for CARB exemption was pending at the time this press release was written. If CARB exemption is required for your application, please contact K&N for current information on the status of its CARB application.

# # K&N # #

RIVERSIDE, CA - For all you die-hard Durango fans, look no further for performance filtration. K&N Engineering's new 57-Series FIPK (Fuel Injection Performance Kits) for the 5.7L Hemi (pictured) and the 4.7L V-8 offer guaranteed horsepower in an easy-to-install kit. Both kits incorporate a cone-shaped original K&N High-Flow Air Filter which is backed by the famous K&N Million Mile Limited Warranty^® and can be cleaned and re-oiled with a K&N Recharger^® Kit (sold separately).

On K&N's in-house Dynojet dynamometer, the FIPK^®, Part# 63-1094, equipped Hemi produced a maximum horsepower output of 273.15 at the rear wheels, an impressive 17.54 HP increase over stock. The 4.7 pulled 174.55 in stock form, jumping to 191.30 HP after the FIPK^® installation. The K&N system maximizes airflow while protecting your engine from harmful particulates as small as .05". The heart of the FIPK^® Intake Kit is its original K&N High-Flow Air Filter, comprised of four layers of woven cotton-gauze fabric, which are sandwiched between aluminum mesh screen, then treated with a specially-formulated filter oil to capture dirt and debris as it smoothes air flowing through the filter.

Connecting the filter to the engine is an aerodynamically engineered, roto-molded polyethylene intake tube designed to smooth airflow and drive massive amounts of air into the engine. As with other FIPK^® applications, the Durango kits come complete with all the necessary hardware and installs easily with no drilling required. This system is street legal in most states.

In addition to this new FIPK^®, K&N also offers two OE-upgrade filters for the new Durango: a washable/reusable replacement air filter (PN 33-2288) and a Performance Gold Oil Filter (PN HP-2004).

For more information, please contact K&N Engineering, Inc., P.O. Box 1329, Riverside, CA 92502-1329, (800) 213-4182 for a dealer near you, (800) 858-3333 for technical service/questions, (951) 826-4001 Fax, e-mail [email protected] or visit www.knfilters.com.

# # K&N # #

RIVERSIDE, CA - Ford and Dodge continue to duke it out for muscletruck supremacy. Just when the Lightning appears to claim the crown, Dodge unveils the 500-HP Ram SRT-10, powered by the Viper-inspired 8.3L V-10. K&N Engineering has been on the fast-truck bandwagon for years and proudly introduces a new 57-Series Fuel Injection Performance Kit (FIPK^®) for the SRT-10, Part No. 57-1541. Dyno-testing revealed that this K&N cold-air system improved horsepower and torque across the powerband. (See the dyno chart at www.knfilters.com.)

The 57-Series FIPK^® system makes more power by replacing the restrictive factory airbox and intake tract. More air into the engine equates to added power.

K&N begins with one of its famous High-Flow Air Filters, isolated from underhood heat by the kit's powdercoated heat shield. Compared to the factory filter, the K&N unit is freer-flowing and traps more dirt. Plus, this filter can be washed and re-oiled with a K&N Recharger^® Kit. Normally outlasting the vehicle, the K&N High-Flow Air Filter comes with the K&N Million Mile Limited Warranty^® and can be serviced as seldom as every 100,000 miles under optimal conditions.

The K&N filter attaches to an aerodynamically designed intake tube that's made of polyethylene. This allows the free-flowing tube to be routed for minimal turbulence and also helps dissipate heat. Installation is easily completed by the do-it-yourselfer. No drilling is required, and the 57-Series kit includes illustrated instructions as well as all necessary mounting hardware.

For the SRT-10, K&N also offers a washable/reusable replacement filter (PN 33-2297) as well as a Performance Gold^® Oil Filter (PN HP-2004).

For more information, please contact K&N Engineering, Inc., P.O. Box 1329, Riverside, CA 92502-1329, (800) 213-4182 for a dealer near you, (800) 858-3333 for technical service/questions, (951) 826-4001 Fax, e-mail [email protected] or visit www.knfilters.com.

* Application for CARB exemption was pending at the time this press release was written. If CARB exemption is required for your application, please contact K&N for current information on the status of its CARB application.

# # K&N # #