2009 and 2010 Ford F-150 Pickups with 4.6L 3 Valve V8 Engine Get Power with K&N
- Jun 21, 2011
Through our tried and tested methods of engineering, that have been fine tuned over the 42 years K&N has been in business, we've been able to achieve an estimated increase of 16.14HP at 4650 rpm with this intake. This high flow air intake achieves these exceptional and realistic numbers by eliminating restrictive points in the stock air intake system. We eliminate the factory air box, stock air filter, resonator chambers and the stock intake tube. We replace these air restrictive components with K&N's high flow intake tube, open element round tapered air filter and heat shield. Our high flow intake tube streamlines air flow by allowing it to flow through the intake tube and throttle body in a highly efficient way. When this is coupled with our high flow open element air filter number RC-5173 we achieve overall better performance. Our 57-2580 Air Charger system will increase horsepower, torque and throttle response. Obviously this tends to result in a more rewarding driving experience. The replacement air filter part for this intake system is RC-5173. It can go for up to 100,000 miles before servicing is necessary depending on driving conditions. This filter also has a K&N Drycharger® wrap option available to give your truck an even longer service interval. K&N filter wraps are great when a lot of your driving is in dusty environments. Our RC-5173DK air filter wrap is water resistant and made from a silicone treated polyester material and can be cleaned using a soapy water solution. Our 57-2580 Air Charger intake system takes about 90 minutes or less to install with common hand tools. It uses stock mounting points, incorporates your vehicle's factory electronic components into the system, requires no drilling and it is covered by the K&N Million Mile Limited Warranty®. Find K&N products for your vehicle using the K&N application search then use the K&N dealer search to find a K&N dealer in your part of the world. |
